What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 23:55
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But… the neutral is now “floating” because of the 1 ohm resistance.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
A circuit breaker is similar, but is resettable.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Here is a simplified AC power diagram.
Is the Be10x AI workshop worth enough?
This is 'the assistant's answer'
In schematic diagrams this is the symbol for a fuse:
There are two important concepts here.
Tinnitus linked to impaired cognitive function - Medical Xpress
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Because the load is inductive, the current lags the voltage.(by a bit).
Which is the best face wash for oily skin?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Edit 2024–10.
FAA Says Newark Airport Should Be OK by October - Newser
The other is “what does a “fuse” do?”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
He then describes Rainy Season and Lightning.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is where the MOV conducts again, and dissipated the energy.
[image of Common-mode choke]
One is “what exactly is in a ‘surge protector’ ? ”
At one ohm, the resistor has a maximum of 1 watt power.
a photo is worth a thousand words.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Elon Musk Says XAI Will Retrain Grok: 'Far Too Much Garbage' - Business Insider
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are three different concepts here that are getting confused.
For this case there are devices called Metal oxide varistors (MOV).
nine
It seems Mohan does not understand the difference between a comment and an Answer.
One
How do I explain to my husband that my 19-year-old son has accidentally gotten me pregnant?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
but this device (an Inductor) … impedes the rapid changes in the current.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
These devices are installed between the “hot” and “neutral” and protective ground.
so, what happens?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
(Dc diagram shown, AC is similar).
This device then solves the entire problem.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This one hit behind the barn.
A fuse is a non-resetable over current circuit protector.
What does a fuse do?
2024–10–14 [Omar Gharbi Omar Gharbi ]
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
what exactly is a ‘surge’ protector?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Now when you have a certain ac resistance, then a current flows in a loop.
He then asserts :
So, the voltage could go up to 500 volts, and the fuse will not open up.
But it can get overloaded, and no longer works.
These are simplified answers to the original question, and does not change anything I wrote above.
He then describes the function of a fuse.
Barnstars:
eight
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
but I think this circuit , shows a few more pieces.
I post the exact comment here.
the problem then depends on "how fast does the fuse operate?".
[old diagram got deleted by accident]
An AC voltage/ current source, and an ac inductive load.
2024–10–16 [ OO OLAOYE OYEBODE ]
It also is a device that limits the change in current flow.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
At least they know the answer if they wanted it.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
First Sentence:
2024–10–10[John johnson John Johnson ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Upvotes:
The third is lightning and “how it gets conducted into a home.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The bolt then partially travels down the line to your home.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What is lightning?